The wiring of the door control is not difficult.

I will include a TinyCAD diagram and an image of same.

There are 3 wires from the computer to the door, one is

12VCD positive ant the other two connect to the relays

Essentially, the relays at rest connect both terminals of the motor

to negative 12V.  Pushing any of the momentary switches connects that

side of the motor and drives the door.  Activating a relay will connect

the motor  and move the door also.  The limit switches are set so the

positive voltage on that lead will be blocked and the motor stopped for

that direction but negative current can flow to move the door in the

other direction. Click on this sentence for a TinyCad drawing.

click on the drawing for the full page.

Be First to Comment

Leave a Reply

Your email address will not be published. Required fields are marked *